BougeRV 12V 600W High Watt Rigid Solar System Kit

Collect sunlight during the day and store energy for your off-grid setup. This BougeRV kit combines two rigid bifacial panels with three LiFePO4 batteries, an MPPT charge controller and a pure sine wave inverter for a properly configured 12V installation.

Listed Package Contents

• 2 x 300W 12V 12BB monocrystalline bifacial solar panels, totaling 600W rated panel power
• 1 x Sunflow 40A MPPT solar charge controller, listed for 12V/24V systems
• 1 x 2000W 12V pure sine wave inverter with Bluetooth
• 3 x 12V 100Ah Group 24 LiFePO4 batteries

The package source identifies the panels as 12BB; confirm the exact supplied panel model rather than substituting specifications from a different 300W panel. Cables, connectors, fuses, disconnects and mounting hardware are not itemized in the supplied list. Confirm complete installation contents before ordering.

Solar Generation & Controller Sizing

The 600W figure is the combined panel rating, not continuous production or guaranteed daily energy. Actual output varies with sunlight, orientation, shading, temperature and system losses. Bifacial rear-side production depends on reflected light and mounting conditions; no specific gain is established here.

Confirm controller support for the complete array: A 40A charge rating alone does not establish that the controller can accept or fully use a 600W array on a 12V battery bank. Verify its permitted PV wattage, input-current and open-circuit-voltage limits, approved array wiring and any allowed oversizing. Charging may be limited by the controller. Allow for cold-weather panel voltage rise when checking input limits.

Battery Storage & AC Output

Each battery is listed as 12V 100Ah. If the manufacturer approves a three-battery parallel bank, a correctly configured set would provide a 12V-class 300Ah bank. Confirm matching, connection limits and balanced wiring requirements. Do not connect a higher-voltage series bank to the listed 12V inverter.

The inverter's listed 2000W rating is separate from the array's 600W rating. Verify continuous and surge output, AC voltage and frequency, outlet configuration and the battery bank's discharge-current capability before selecting appliances. Runtime depends on usable stored energy, load and conversion losses; loads may use energy faster than solar charging replaces it.

Installation Planning

The controller's listed 12V/24V support does not make the complete kit a 24V system: the inverter is specified for 12V. Configure charging for the exact batteries' LiFePO4 requirements and confirm charge/discharge limits, low-temperature charging restrictions and protection features.

Check panel dimensions, mounting clearances, battery fit, installed weight and environmental ratings for every component. Follow the exact manuals for secure mounting, ventilation, cable sizing, fusing and grounding, using a qualified installer where appropriate.

Bluetooth is listed for the inverter, but its app, range and control functions are not specified. This component kit is not established as plug-and-play household backup or a grid-connected system. No fixed charging time, appliance runtime or waterproof-system rating is supplied.